Diamax Cyclone Stock Removal Wheel – 2 in. x 2 in., 60 Grit Medium
Diamax Cyclone Stock Removal Wheel – 2 in. x 2 in., 60 Grit Medium
The Diamax Cyclone Stock Removal Wheel is a 2 in. x 2 in. stock removal wheel, 60 medium grit, for removing radius stock chip-free on granite and engineered stone.
The wheel is sold to take the radius stock off an edge without chipping it, and Diamax recommends oscillating it up and down so it wears evenly rather than cutting a groove.
Key Features
- 60 medium grit, 2 in. x 2 in.
- Removes radius stock chip-free, with no vibration
- 5/8 in.-11 thread
- Maximum 4,000 RPM
- Wet use only
Not Recommended For
Not a polishing or finishing wheel — it is a stock removal step, and the surface it leaves goes on to a resin pad such as the Diamax Cyclone Premium R Series Wet Polishing Pad – 4 in., 3 mm Resin. Running it dry will glaze it; Diamax specifies wet only.
Who Is This For?
Fabricators taking the radius off an edge before polishing, where chipping at this stage costs an hour later.
Frequently Asked Questions
What is a stock removal wheel for?
Taking radius stock off an edge without chipping it, before the polishing sequence starts.
How should it be used?
Oscillate it up and down as you work so it wears evenly instead of cutting a groove into itself.
Wet or dry?
Wet use only — this line is not published for dry work.
What is the maximum RPM?
It is rated to a maximum of 4,000 RPM.
What grits does Diamax publish?
This line is published in 36, 60 and 120 grit.