Zenesis Miter Bridge Saw Blade – 14 in., 10 mm Segment
Zenesis Miter Bridge Saw Blade – 14 in., 10 mm Segment
The Zenesis Miter Bridge Saw Blade is a 14 in. wet-cut bridge saw blade with 10 mm segments on an extra-heavy-duty silent core, built for miter cuts and straight cuts in natural and engineered stone.
Miter cutting loads the blade sideways as well as downward, and a tall segment flexes at the weld under that load. Zenesis uses a short 10 mm segment and a reinforced core so the blade tracks straight through a 45-degree cut and leaves a seam that closes clean. It cuts straight just as well, so shops that miter often run it as their everyday blade. For long straight-cut life in granite and quartz with a 25 mm segment, the Zenesis Black 4 Bridge Saw Blade – 14 in. is the higher-life option.
Key Features
- 14 in. blade diameter
- 10 mm segment height, patterned diamond
- 60/50 mm arbor
- Extra-heavy-duty silent core to minimize flexing
- Wet use only, bridge saw
- Zenesis materials: all natural and engineered stone
- Zenesis RPM chart recommends 1,700–2,000 RPM for 14 in. bridge saw blades
- Pin-hole pattern is not published for this size and is not stated here
Not Recommended For
Porcelain and ultra-compact slabs are not among the published materials; use the Alpha Silencer III Bridge Saw Blade – 14 in., for Dekton & Sintered Slabs. For marble, Zenesis makes a dedicated marble bond, the Zenesis M Bridge Saw Blade – 16 in., 10 mm Segment, for Marble.
Who Is This For?
Countertop shops doing mitered edges, waterfall ends and laminated build-ups on a bridge saw who need the seam to close without hand work, and who want one blade for both miter and straight cuts.
Frequently Asked Questions
Why a 10 mm segment on a miter blade?
Zenesis states that 10 mm segments do not flex at the weld under the side stress of a miter cut, which is what keeps the cut straight and the seam tight.
Can I use it for straight cuts too?
Yes. Zenesis rates it for both miter and straight cuts in natural and engineered stone.
What RPM should I run?
The Zenesis RPM chart recommends 1,700–2,000 RPM for a 14 in. bridge saw blade, and advises reducing feed rate 20–30% on miter cuts.
Is it wet or dry?
Wet use only.
Does it cut porcelain or ultra-compact slabs?
Zenesis publishes it for natural and engineered stone. For porcelain and sintered slabs use a porcelain bridge saw blade such as the Alpha Silencer III Bridge Saw Blade – 14 in., for Dekton & Sintered Slabs.