Vincent 45 Degree Miter CNC Peripheral Wheel – Position 1 Roughing, 140 mm Diameter

The Vincent CNC mitre-system wheel is a 5.51 in. (140 mm) position 1 45° segmented profiling wheel for cutting 45° mitres on granite and engineered stone on a CNC.

Spindle speed: 4,800–5,500 RPM
Feed rate: up to 39 in./min (1,000 mm/min)
Stock removal: up to 0.008 in. (0.2 mm)

Diameter: 5.51 in. (140 mm) · Bore: 1.38 in. (35 mm)

Key Features

• The mitre system runs its own parameters. Vincent publishes up to 39 in./min (1,000 mm/min) at 4,800–5,500 RPM for the 45° wheels — far slower than the 374 in./min (9,500 mm/min) the same catalogue publishes for position 1 profiling wheels, because a mitre wheel is cutting a full 45° band, not a profile edge.
• Position 1 of a two-step mitre sequence: the segmented wheel hogs the bevel, the continuous band wheel cleans it up for the glue joint.
• Stock removal up to 0.008 in. (0.2 mm).
• 1.38 in. (35 mm) bore, 5.51 in. (140 mm) diameter.

Who Is This For

A high-production shop building mitred waterfall ends and thick-edge laminations on the CNC, where the joint has to close without filler. Edge quality on a mitre is measured at the glue line: the continuous band wheel is what removes the segment marks the hogger leaves, so there is no hand blending before the joint goes together.

It is not a profiling wheel and its table is not the profiling table. Do not carry the position 1 or 2 feed rate from the profile range onto a mitre wheel — the catalogue publishes different figures for a reason.

When you are removing a lot of material, Vincent asks for more passes rather than one heavy pass.

Frequently Asked Questions

What feed rate for a 45° mitre wheel?
Vincent publishes up to 39 in./min (1,000 mm/min) at 4,800–5,500 RPM, with stock removal up to 0.008 in. (0.2 mm).

Can I use the profiling-wheel parameters?
No. The mitre system has its own table in Vincent's catalogue and the figures are much lower. Running profiling feed rates on a mitre wheel is how the band gets torn.

What bore?
1.38 in. (35 mm).

What slab thicknesses does the mitre system suit?
Vincent lists the mitre system as suitable for 0.79 in. (20 mm) and 1.18 in. (30 mm) slabs — 2 cm and 3 cm material.